Answered>Order 9533

This program needs to be designed in ladder logic, then ran in LogixPro software to verify it works. 

Design a program that will move boxes to a filling station while the SELECTOR SWITCH is in position A.

·        When the START switch is pressed, the RUN light should come ON.

·        The first box arrives at the filling station and activates a PROX SENSOR, then activates a 5 second timer to pause the process then starts filling the box after 5 seconds is complete.

·        While the box is filling, the FILL light should flash ON/OFF at a 1 second interval. The FILL light should go OFF when the box is full. 

·        Once the box is full, the FULL light should come ON, and activate a second timer to wait an additional 5 seconds.

·        After the last 5 second interval is complete, the box should move away from the fill station, and the FULL light should go OFF, so the next box can arrive to be filled.

·        The process should repeat.

·        Once 10 boxes have passed the PROX SENSOR, the process should shut down. Also the RUN light should go OFF.

·        To restart the process, move the SELECTOR SWITCH to positon B to reset the counter. Move the SELECTOR SWITCH back to positon A, depress the START SWITCH to restart the system for the next 10 boxes.

·        If the STOP switch is pressed the system will stop, and the RUN light should go OFF.

·        The START switch will have to be pressed to start the control system again.